97 RedSS
07-28-2007, 04:09 PM
Been 3-4yrs since I've had any refrigerant in my AC lines so today(95 degrees+) I had a shop pull a vacuum and fill with fluid..
Problem is we couldn't get the compressor to pull in no matter what. Instead of paying him alot of $$$, I thought I would take it home and troubleshoot on my own...he was thinking since I had the custom program in my PCM it could be turned since I didn't have the AC before...
Anyways, I've done alot of troubleshooting and it looks like everything is working correctly to get the power to the compressor.- I pulled off the connector at the compressor and it's getting 12 V so it should be pulling in correct???
It isn't frozen or anything and I tapped on it with a rubber mallet to see if that would get me anywhere..
Any suggestions..
Thanks
Cody
Problem is we couldn't get the compressor to pull in no matter what. Instead of paying him alot of $$$, I thought I would take it home and troubleshoot on my own...he was thinking since I had the custom program in my PCM it could be turned since I didn't have the AC before...
Anyways, I've done alot of troubleshooting and it looks like everything is working correctly to get the power to the compressor.- I pulled off the connector at the compressor and it's getting 12 V so it should be pulling in correct???
It isn't frozen or anything and I tapped on it with a rubber mallet to see if that would get me anywhere..
Any suggestions..
Thanks
Cody