Running New Fuel Lines

I need to run new lines, stock lines are running way too close to my exhaust for my comfort. Any suggestions on the best way to do this?

I am assuming I'm going to be dropping the tank, using the compression-AN fitting pieces on each end (tank and fuel rail) to convert and plumb a new filter in-between.

Would be interested in any short-cuts that would allow me to not have to drop the tank. On the supply side I could just go from the fuel filter on up but not sure if there are any work-arounds for the return?

Any suggestions would be appreciated!

You an just use the compression fittings on the hardlines from underneath the car and re route the lines using stainless braided lines.

-B

You can cut a square out of the top of your trunk to access the fuel pump area if need be with a dremel tool.

Just an option

Clint