RacingTiger04
12-27-2006, 08:08 PM
Well due to an unfortunate accident its time to rebuild the rear-end from the ground up against my will.. I found some axles on summit racing for 317 shipped a new eaton posi 28 spline for 520 before shipping.. then of course $400 for the shop install (if only i had the time for this project.. but i dont think i could setup the gears right anyway)
Anyhow does this sound like a pretty good setup? changes recommendations and any missing things welcome (will most likely be re-using my 3.73 motives or adding $35 to the total and getting the 3.73 strange with the posi)
as far as what happened for those of you wandering, the ole Z sidestepped on me pullin out to the left from a redlight (it always has at this spot and didnt surprise me in the least till i heard a loud bang and found my wheel to be shattered along with what i believe is a bent axle :( ) figure i might as well run the gauntlet and rebuild it all while its apart for the axle.
Anyhow does this sound like a pretty good setup? changes recommendations and any missing things welcome (will most likely be re-using my 3.73 motives or adding $35 to the total and getting the 3.73 strange with the posi)
as far as what happened for those of you wandering, the ole Z sidestepped on me pullin out to the left from a redlight (it always has at this spot and didnt surprise me in the least till i heard a loud bang and found my wheel to be shattered along with what i believe is a bent axle :( ) figure i might as well run the gauntlet and rebuild it all while its apart for the axle.