ATI D1 oil fitting?

Does anyone know what size the fitting from the oil feed line to the block is? I bought the blower used and the guy forgot about the fitting.

-B

ttt

my p600b's is a -8. I think its a -3 for the pressure side.

Nah -8AN is away too big. I'm talking about the fitting that screws into the block right above the oil filter. I have the stainless line that goes from the blower to the block though.

-B

I am pretty sure the thread in the block is a 1/4" tapered pipe tap. If not then it's a 1/8" tapered pipe tap. Almost 99% sure it is the 1/4" though. Sorry to confuse you even more.........John

editted...

3GAOL-001 / LT1 FBODY P600 OIL SYS BAG
CL006I-1SS #06 HOSE CLAMP -3/8" - 7/8" 1.00 EACH
GF002I-001 3/8" MPT-1/2" BARB 1.00 EACH
GF008I-001 -8 FEM. SWIVEL X 1/2 P/L BARB (OIL 1.00 EACH
OF001A-001 OIL "T" FITTING W/ 3" NIPPLE 1.00 EACH
OF001I-004 1/4" MPT - (-4) MALE FITTING 1.00 EACH
OL004I-001 RUBBER OIL FEED LINE W/ FITTINGS 1.00 EACH
OL016A-002 OIL RET LINE LT1F 1.00 FT

From the bill of materials LT-1 P600B-D1 kit