Supporting Vendor Index    -    Advertising Information
PDA

M6 PCM controlling TCC?

Dave89IROC
04-18-2006, 08:57 PM
ok, a 94/95 M6 Calibrated PCM, is there a way in tunercat to make it control a lockup convertor(in a swap, 700R4)?
LiT1_up
04-18-2006, 10:12 PM
I not an expert but I don't think so.
Dansean1
04-18-2006, 10:47 PM
If the new trans is a 700R4 its all vacuum, non electrical. For your current PCM, you will have to get a compatiable file for your PCM for an A4, but a 700R4 is not controlled by the PCM.
Im not a 100% sure so check on it.
Dave89IROC
04-19-2006, 01:10 AM
If the new trans is a 700R4 its all vacuum, non electrical. For your current PCM, you will have to get a compatiable file for your PCM for an A4, but a 700R4 is not controlled by the PCM.
Im not a 100% sure so check on it.

700R4s still used electric for the lockup convertor


OK, can a A4 file control just the lockup, without the other functions?