I am looking to get a 93+ Camaro. I just recently sold my T/A and wish I didn't.

Looking to get a 93+ camaro that is an LT1/M6/AUTO (must be the right car to be an auto.)
Can be high milage car but must run good, and look good
Will take offers on 3.8 m5/auto cars

If a trade is offered I will pay for your gas to drive the car here and take a look at the truck. But only if we trade, If theres no trade then no gas.

1991 silverado standard cab 8' bed
Custom Soild axle conversion
6" BDS springs w/ 1.5" of lift from SFA conversion
3/4 ton dana 44 & corp 14 bolt FF rear
4.56 gears front and rear with rear locker

35x 14.5x 16 ground hawgs, on owasis rims & 36x 14.5x 16.5 swamper TSL radials on black steel wheels

94 front clip, front lockouts, custom front drive shaft

custom mixed 2 stage blue (needs buffing minor run in front passanger fender)
2 1/2" flowmaster dual exhaust with 4" stainless tips



Built 360ci SBC with 9/1 compression
Stage 2 superchip
Comp cams TBI cam 1500-6000rpm
Dual electric fans (1 by temp & 1 by switch)
180* thermostat
Flowtech headers ( need replaced "cracked driverside")
Accell wires, cap rotor, pickup, module and plugs 150 miles ago.

Complete intake gasket, TBI, EGR, DIST, GASKETS all replaced 150 miles ago
(The truck had a little oil leak caused by bad seal in the RTV by the oil sending unit) so all the upper gaskets were all replaced cost $500 to replace gaskets & parts, and to TUNE the motor for the cam & TBI, "have recietes")

Im asking $4500. make me an offer. I will sell for less with only one set of tires, I do have some old picks, new ones will be taken in a few days.

Truck is located in Jackson, michigan

 

http://i42.photobucket.com/albums/e3...r/034ec1f0.jpg

http://i42.photobucket.com/albums/e3...r/fa633dd3.jpg

DATES ARE WRONG ON PICS TAKEN IN ........DEC 2005........

http://i42.photobucket.com/albums/e3...r/000_0007.jpg

http://i42.photobucket.com/albums/e3...r/3f97dd70.jpg