|
||
Accel Gen 6 wiring instructions????taner 01-14-2006, 06:14 PM I can't find all of my paperwork for the DFI, I am mainly wondering what the 3 wires on the n2o are. ie, ground, positive, solenoid enable, etc.... does any one have this and can verify or possibly have a link availalbe to view this at. tia! taner The Big Show 01-15-2006, 11:50 AM Give Mac a call at Fast Track Performance (http://www.fasttrackperformance.com/) and he should be able to fax you over what ya need. taner 01-15-2006, 08:44 PM thanks Bobby, i speak with Mac regularly. i actually have an emailt o send to him with regards to a few questions. i will cover it at that time, just wondering if anyonehad something handy. besides i know he is super busy!!! The Big Show 01-16-2006, 10:09 AM thanks Bobby, i speak with Mac regularly. i actually have an emailt o send to him with regards to a few questions. i will cover it at that time, just wondering if anyonehad something handy. besides i know he is super busy!!! Do you have a fax number? I have the wiring stuff in the garage and I am "suppose" to go out there today to do a few things so I can look and see if I can find it. taner 01-16-2006, 11:03 AM 519-945-5599 thanks Bobby! 'nother question for ya......i too will be installing the lovely opti delete cover :) did you just rtv the back side or o ring it? The Big Show 01-16-2006, 01:33 PM 519-945-5599 thanks Bobby! 'nother question for ya......i too will be installing the lovely opti delete cover :) did you just rtv the back side or o ring it? No need to rtv it. it's got a big cyclinder that goes into the seal (make sure you change this) and seats itself so no need for the rtv. I'm still looking for it. I hope I didn't throw it away. It was given to me on accident because my 93 instructions are different from the 94-up. ltlhomer 01-17-2006, 10:44 PM Accel usually has their diagrams on their website...I know they have their Gen 7 stuff on there. It's built into the actual software which is also free for download. taner 01-17-2006, 11:04 PM i found the one sheet yesterday, then i misplaced it again! holy **** man. i will check their site! thanks! Tweaked Zed 01-19-2006, 11:00 PM Hey Taner, How's it going? Just wondering if you already have an opti block off plate. I've got one laying around off the 396 I never could get rid of. Bryce. | ||