MarkM
06-06-2005, 02:21 PM
I'm using some '95 Camaro rear calipers, and I'm trying to makes some braided hose for the rear. I can't figure out what banjo bolt to use.
My local speed shop has 10mmx1.25, which looks like the same thread size. But when trying to bold it in, it went in a little ways, then snugged up. And the threads looks shiney, like the bolt was removing material. The calipers I'm using are new rebuilt units, so maybe the threads are a little rough.
Anyone know what thread size I should be using?
My local speed shop has 10mmx1.25, which looks like the same thread size. But when trying to bold it in, it went in a little ways, then snugged up. And the threads looks shiney, like the bolt was removing material. The calipers I'm using are new rebuilt units, so maybe the threads are a little rough.
Anyone know what thread size I should be using?