Wiring Diagram Look Good??

I just got a NX wet kit from here and it didnt come with wiring instructions. So I used the wiring setup on page 3 diagram 2 of this page. should this work fine? http://www.barrygrant.com/fromBarryGrant/NitrousWorks%20Instructions/GM-TPI-NITROUS.pdf Also I dont have a full throttle pusbutton but I have a Jimmy jams WOT is that the same?

Yes, that wiring diagram should be fine, since all solenoids work the same. If you're looking for NX specific instructions, they can be found here:

NX Instructions (http://rocketworldracing.com/store/Instructions.php)

Yea I found that one but apperantly the relay switch is different from that one because I have no white wire. Thanks for the confirmation

BTW Where should I hook up the switched power supply inside the car. Is the ORANGE wire under the shifter good to splice into?
Also I just checked the system I dont have to switches hooked up yet, but I put the wire that hooks up to the switches to the orange on the cig lighter (just to test). The car was running and I have No nitrous in the bottle yet but the fuel is hooked up. It started making clicking noises and a little fuel sputs out. Iam I in trouble?? I thought the fuel would spray out? or does it spray out when you get the nitrous and fuel mixed?

The wire you use should be able to handle the current from the nitrous system... I would use the ignition wire... Test the pink wire in the ignition harness. Make sure you fuse everything!!!! Use a meter, and make sure you solder into the right wire...

It's hard to say if you have everything hooked up correctly without looking at it, but with a small jet, the fuel doesn't usually "spray" out. The nozzle will atomize the fuel with the nitrous when they are mixed.

Ok thanks sound like I got it down. Ill test that pink wire. How much volts should it be?

Should be a 12volt ignition wire.

Cool! thanks Mean SBC!! :bow:

No problem... :)