Ported Ls1 heads
Thread Starter
Registered User
Joined: Jul 2001
Posts: 718
From: Wichita Falls,Texas
Ported Ls1 heads
I have a set of #806 (97-98) castings that were hand ported by Elliot's port works in Red Oak, Texas. They will come with stock valves 2.00/1.50 and stock valve springs. They were only ran for 500 miles or less. Selling because I need some money to pay some bills. Flow #'s are below. I'm asking $500 + shipping or Ran a best of 7.46@96 N/A on a spinning 1.7 60ft with them in the 1/8th. These heads will be a direct bolt on to any ls1 or ls6 block only valve covers are teh diffrence and i will include those if needed.
LIFT INT EXH
.100 65 48.4
.200 135.1 105.4
.300 201.8 139
.400 247.9 181.7
.500 279.6 196.1
.550 281.9 201.8
.600 283.4 206.6
Exhaust was flowed with out a pipe.
Pics are HERE
LIFT INT EXH
.100 65 48.4
.200 135.1 105.4
.300 201.8 139
.400 247.9 181.7
.500 279.6 196.1
.550 281.9 201.8
.600 283.4 206.6
Exhaust was flowed with out a pipe.
Pics are HERE
Last edited by Smoke T/A; Jun 8, 2004 at 06:29 PM.
Thread Starter
Registered User
Joined: Jul 2001
Posts: 718
From: Wichita Falls,Texas
Originally posted by FLIPPINZ28
hey were your times on a stock engine if not what have you got done to run a 7.46 spinning so the heads will be complete when i get them. thanks kenny
hey were your times on a stock engine if not what have you got done to run a 7.46 spinning so the heads will be complete when i get them. thanks kenny
Joe
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
Oct 31, 2016 11:09 AM
oldschool
Parts For Sale
16
Feb 9, 2016 09:21 PM
Wilson
Car Audio and Electronics
0
Jul 21, 2002 05:08 PM