I'm thinking about going a slightly different route with my engine, and I'd like to see if there is any interest in these heads. They are brand new and have never even been bolted on. Brodix Track1's, Ferrea 6000 Series 2.08/1.60 Valves, Comp 978 Springs, Comp Steel Retainers, and ARP Rocker Studs. Heads are completely assembled and ready to go. Flow numbers are:

.200 136/103
.300 194/143
.400 246/175
.450 266/190
.500 285/199
.550 298/206
.600 308/210
.650 310/214
.700 310/217

The valves could be back cut for more low lift flow if you wanted it. Asking $2000. If no one wants them then I'll just bolt them on and run them.

 

up top

 

what else is needed for those puppies? Just wondering, are they already converted to reverse flow?

 

They are ready to bolt on and go for any gen1 SBC. They have not been converted to reverse cooling for an LT1 application.