FS T56, clutch, shifter, headers injectors and Drive shaft
Thread Starter
Registered User
Joined: Nov 1999
Posts: 310
From: frederick MD.
FS T56, clutch, shifter, headers injectors and Drive shaft
(SOLD)T56 complete with bell housing approximately 5k since last rebuild in excellent condition with Hurst shifter and SPEC Stage 2 Kevlar clutch steel flywheel clutch needs new disk the rest is in excellent condition. (SOLD)
$1200
96/97 JBA headers coated $250
50# MSD injectors like new $300
Dennys Nitrous Ready Drive Shaft with 1350 pinion yoke and billet input shaft yoke $350 this is absolutely the strongest DS you can BUY>>
(SOLD)Strange 3.73 gears for 3 series 10 bolt new in box (SOLD)
Jeff
96 SS BLOWN
96 TA 396 D1
$1200
96/97 JBA headers coated $250
50# MSD injectors like new $300
Dennys Nitrous Ready Drive Shaft with 1350 pinion yoke and billet input shaft yoke $350 this is absolutely the strongest DS you can BUY>>
(SOLD)Strange 3.73 gears for 3 series 10 bolt new in box (SOLD)
Jeff
96 SS BLOWN
96 TA 396 D1
Last edited by Jeff 96 SS; Dec 12, 2003 at 02:50 PM.
Registered User
Joined: Apr 2003
Posts: 41
Registered User
Joined: Mar 2003
Posts: 980
From: batavia, ohio
if u sell the clutch to the other guy, let me know and i WILL buy the tranny and other tranny stuff from you. email me at dj_branam@hotmial.com
in need of that tranny bad!!!!
in need of that tranny bad!!!!
Thread Starter
Registered User
Joined: Nov 1999
Posts: 310
From: frederick MD.
The headers are the JBA 1 5/8 desigined to bolt up to 96/97 Y- pipe. I do have a y-pipe but it is a custom y-pipe and won't do you any good unless you have or are planning to install a 4-inch mufflex.
I have not really considered selling the tranny stuff seperate but Please e-mail me offers on the stuff and if I can sell it all I will seperate.
Jeff
96 SS BLOWN
96 TA 396 D1
I have not really considered selling the tranny stuff seperate but Please e-mail me offers on the stuff and if I can sell it all I will seperate.
Jeff
96 SS BLOWN
96 TA 396 D1
Thread Starter
Registered User
Joined: Nov 1999
Posts: 310
From: frederick MD.
They are High Impeadance injectors and will work with your stock pcm. They will easilly support 550RWHP some have been able to push low 600RWHP range with these injectors.
Jeff
96 SS BLOWN
96 TA 396 D1
Jeff
96 SS BLOWN
96 TA 396 D1
Thread Starter
Registered User
Joined: Nov 1999
Posts: 310
From: frederick MD.
Yes they will bolt up to your stock Y-pipe. the headers don't have alot of miles but they were on the car for 2-1/2 years Give me an E-maill address that you would like the PICS sent to and I'll get them to you this evening.
Jeff
96 SS BLOWN
96 TA 396 D1
Jeff
96 SS BLOWN
96 TA 396 D1