parts needed
I have the plastic upper rad. support with the stickers and all, like new from a 94 Z28 and a driver's side (left?) splash gaurd deal that screws to the bottom of the front bumper cover from a 98. Is that the part you are looking for? It is the same as a 94, but the newer ones like this have a flap were you can undo two bolts and swing it down. Awsome if you have like a SLP CAI that has the filters down there. You wouldn't have to take out 20 bolts each time. Let me know if these are the parts and I'll e-mail you a price. I take Paypal too. Thanks.
the rad support is correct but does the splash guard go from the bottom of the front nose piece (two bolts hold it on ) up and around the top of the tire & down to thebottom of the fender.. its about 4-5 ft long & 1-1 1/2 ft. wide .. if so how much are you asking??????
Tried to send the tracking # , but again your e-mail is coming back undeliverable. It's on the way though. Thanks.
The original message was received at Thu, 23 Oct 2003 19:15:25 -0600
from dial-111.r16.mtwgln.infoave.net [216.228.38.120]
----- The following addresses had permanent fatal errors -----
<kayfoster@ladelphia.net>
(reason: 550 Host unknown)
----- Transcript of session follows -----
550 5.1.2 <kayfoster@ladelphia.net>... Host unknown (Name server: ladelphia.net: host not found)
The original message was received at Thu, 23 Oct 2003 19:15:25 -0600
from dial-111.r16.mtwgln.infoave.net [216.228.38.120]
----- The following addresses had permanent fatal errors -----
<kayfoster@ladelphia.net>
(reason: 550 Host unknown)
----- Transcript of session follows -----
550 5.1.2 <kayfoster@ladelphia.net>... Host unknown (Name server: ladelphia.net: host not found)
Thread
Thread Starter
Forum
Replies
Last Post



