OK fellas,
I finally borrowed a digital camera to take pictures of my 'Home Depot' blowdown set up, but cannot figure out how to post them. If someone can assist me I would appreciate it.
Thanks

------------------
1994 Z/28, M6,T-Tops
TNT F1 Wet Kit, Centerforce clutch,
17" SS wheels, 275 Goodyear F1's, K&N CAI, HPP 3, 160 Thermostat, 3" custom Cat-Back exhaust with glasspack, Ported MAF, Hurst Billet plus shifter,Cold-air scoop, and an additonal mod or 2 for extra fun.

 

Just go set up a webshots account to post the pics!

www.webshots.com

Here on the message board post the parts used and cost please. Also, did you actually pass tech with this set up? Did they give you any static?

 

You can also setup an Camaroz28.com readers ride web page. Free and has an easy template/drop menu design.

------------------
If I'm playin, I'm sprayin

93 Z28 A3 - w/ Jet Hot coated Hooker LT's and true 3" duals
(hiflow cats, cutouts, and Car Chemistry insert mufflers)

[This message has been edited by speedmiser (edited July 04, 2002).]

 

All I did for my tube (NX) was bend it close as possible and the put a compr. fitting with some 1/2 copper tubing down to a bulkhead fitting in the floor. My bottle's in the spare tire well. Cost bout 15 bucks, took bout 10 minutes to install. They never even checked my car at tech last night so I dont know if it will pass or not seems like it should.

------------------
96Z M6, 12 bolt Moser(3.73),NX wet kit(all the goodies),MSD 6AL,tayor spiro-pro,NGK tr-6,Star stage 2 kevlar,pcmforless programing, SLP CAI,!maf,LT4 NM,Flowmaster,Hurst roll control,BFG DR's,Pro 5.0,BMR DS loop...
13.52-103.8 mph
60ft. 1.99
no n2o times yet