Anyone know of a good site that shows how to port an intake manifold?

I found out that my TorkerII has a carb stud hole stripped out. ANd its the one that I really need to be tight to hold my throttle braket.

I have an old weind action plus. I would assume that if I ported it it would be just as good sa my current intake. Actualy I needed to use a dual plane anyway. But especailly being that its an older intake It would really need to be ported. ANyone know where I can get good instructions on this?

TPIS has a book called "power hints" I think that tells you how to do it. Its listed on there web site. Just look up "TPI specialties".

Also you might check with Popular Hot Rodding or Hot Rod mags. I know that they have done a few features on the subject and most of their articles are accessible over the web. Hope that helps.

ALready did it now, dont know if I did a good job or not, but I really dont care. I doubt it will make a noticable difference. I was just bored at the time :thumb: