bolt pattern on 92 camaro z28???help
#1
bolt pattern on 92 camaro z28???help
i thought id ask you guys since you guys own this cars, me and my friend are planning on sharing rims for drags tires, he owns a 92 camaro z28 tpi, and i own a 94 camaro z28 lt-1, i waS wondering if its the same bolt pattern, hopfulley they are? what do you guys think?
#4
Yes, your bolt pattern is the same, you just have to watch to mach sure the rims dont rub the calipers/drums. I put some SS rims on my 89 iroc WITH OUT spacers and they rubed my calipers, eeehhh good thing they werent my rims, i let a guy with a 97 SS use my slicks for a few runs and i was going to run his street tires. Well he got to run but i didnt. Good luck with yours though.
#6
The bolt pattern is the same for the 3rd and 4th gen but the required offset if very different.
The 3rd gen will require a wheel with an off set of around 0mm. While the 4th gen needs an offset in the 50-60mm range.
For example, a 4th gen rim will not bolt directly onto a 3rd gen. You have to utilize spacers.
However a 3rd gen rim will bolt on a 4th gen, but the wheel will stick out past the fender lip about 2-3"
What type of rims were you planning on using? Stock 3rd or 4th gen rims? Aftermarket rims? What are the specs on it? Rim width, diameter, offset, backspacing?
The 3rd gen will require a wheel with an off set of around 0mm. While the 4th gen needs an offset in the 50-60mm range.
For example, a 4th gen rim will not bolt directly onto a 3rd gen. You have to utilize spacers.
However a 3rd gen rim will bolt on a 4th gen, but the wheel will stick out past the fender lip about 2-3"
What type of rims were you planning on using? Stock 3rd or 4th gen rims? Aftermarket rims? What are the specs on it? Rim width, diameter, offset, backspacing?
#8
Originally posted by ram air camaro
do you know the bolt pattern are they all the same?
do you know the bolt pattern are they all the same?
#11
Originally posted by irocz8957
yeah they should always be same but i know you can't take wheels off of a 4th gen and put them on 3rd gen or vice versa
yeah they should always be same but i know you can't take wheels off of a 4th gen and put them on 3rd gen or vice versa
Thread
Thread Starter
Forum
Replies
Last Post
CamaroHeed
Car Audio and Electronics
17
03-18-2020 09:50 PM
Brandon Wittmer
General 1967-2002 F-Body Tech
3
12-03-2014 09:28 PM
2000silverz28
Car Audio and Electronics
5
07-20-2002 06:14 AM